Technical guide · Updated 2026-11-11
Checkweigher vs Checkweighing Scale: What Is the Difference?
A static checkweighing scale and a dynamic in-line checkweigher solve different problems. Here is how to choose, with the CW series as a worked example.
This guide applies to Definition Electric Ex balance, weighing module and checkweigher installations. Certificate numbers, protection markings, IP ratings and interface details are stated explicitly so they can be verified against the delivered nameplate.
Static check weighing
A static checkweighing scale is a bench or floor scale with HI / OK / LO set points. An operator places each item on the pan, waits for a stable reading, reads the result and removes it. It is accurate and inexpensive but adds a manual step to every unit.
Dynamic in-line checkweighing
A dynamic checkweigher weighs the product while it moves. The CW series carries each carton, bag or single item across a powered roller weighing section; the controller compares the live weight with the target and the upper / lower tolerance limits, then drives a three-colour tower light and, where fitted, a reject device.
The three steps on the line
1) Infeed - powered rollers and side guides centre the product. 2) Weigh - the platform samples 120 times per second. 3) Decide - a pass continues down the line; an over or under raises the alarm, stops the line or fires the reject device.
What to specify
Capacity, division and belt width are fixed at order to suit the product weight, tolerance and the widest pack. Also state line speed (up to 10 m/min on the standard CW), the required data output (RS485 Modbus RTU) and whether automatic rejection is required.
When a static scale is still right
For low throughput, spot audits or goods-in sampling, a static IP68 balance with RS-232 output may be the simpler and more economical answer. Where every pack must be verified at line speed, use a dynamic checkweigher.
Questions engineers ask
How fast can the CW checkweigher run?
The standard machine runs at up to 10 m/min with 120 A/D conversions per second. Throughput depends on pack length and pitch.
Is a reject device standard?
No. The three-colour tower light and line-stop alarm are standard; an automatic reject device, touch-screen HMI, printer and enlarged tower light are options.
Specifications are typical and subject to change. Always verify the approval marking and certificate against your hazardous-area classification before installation.